Heater controller for single and two-phase electric heaters. Controls by supply* or room temperature. Has an internal temperature sensor in casing, supply air temperature sensor is required for operation in both modes.  

Controlled power: 

1x230V – 3.2kW

2x400V – 6.4kW

Maximum current: 16A

*Sensor should be ordered separately.

Heater controller for single and two-phase electric heaters.

Controlled via external 0..10V signal. 

Controlled power: 

1x230V – 3.2kW

2x400V – 6.4kW

Maximum current: 16A

For more information contact sales department.

Controller for three-phase electric heaters with power up to 240kW. Controls by supply or extract air temperature sensors* or an external 0..10VDC control signal. 

Extra steps activated by sequential or binary mode, depending on heater power.  

Models and maximum outputs:

*Sensors should be ordered separately.  

Controller for three-phase electric heaters with power up to 480kW. Controls by supply or extract air temperature sensors* or an external 0..10VDC control signal. 

Extra steps activated by sequential or binary mode, depending on heater power.  

Models and maximum outputs:

*Sensors should be ordered separately.  

TR5K – external wired remote setpoint for NI type heaters. The heater is working based on supply air temperature sensor. 

TR5KNTC10 – external wired remote setpoint for NI type heaters with internal temperature sensor. When connected, the heater is working according to the internal sensor, and the supply air temperature sensor limits supply air temperature – +15°C…+40°C.